UFS200 - 2in Ultrasonic Flow Sensor, NPT

$1,426.43
In stock
SKU
M80132
  • No straight-pipe requirement!  Place immediately after a bend or valve, even in the same valve box  (Jumbo size valve box recommended for easiest fit)
  • Read very low and high flow, all in one sensor
  • No moving parts for greater reliability and allowing blowout for winterization with the sensor installed
  • Pressure rated to 200 PSI and an operating temperature of 32 - 150 degrees Fahrenheit
  • On-board LED Lights indicating power, full pipe status, relative forward flow rate, and reverse flow
  • Simple setup at the controller with a standard K and Offset value for wide compatibility
  • Uses internal ultrasonic transducers and acoustical reflectors to sense flow
  • Designed for outdoor or underground applications (upper electronics are IP 68 / NEMA 4X rated)
  • Glass Filled Nylon body construction for high pressure rating (200 PSI)

Flow Sensors Enable Key Controller Features

Flo-Watch™. Flo-Watch constantly monitors for low flow and excess flow conditions caused by broken lines or heads, automatically quarantines and shuts down the problem area, and continues to irrigate non-affected areas. Saves water, saves plant material, and enables irrigation programs to continue and complete

Learned Flow. The controller automatically learns station flow rates resulting in more accurate flow rates. The automatic collection prevents you from having to manually enter data from drawings, or physically visiting each valve to collect flow data and manually entering the data into a controller

FloManager®. FloManager determines the optimal station irrigating sequence. The system runs at its fullest capacity until programs are complete. The controller automatically selects and runs multiple valves at the same time within hydraulic parameters, allowing for shorter water windows

Sensor Features Specs

Flow Range

UFS200 - 1.0 - 200 GPM
Sensor
Accuracy: +/- 2% across full flow range
Velocity: 2-20 Feet (0.6-6.1 meters) per second depending on model and system specifications
Pressure: 200 PSI Working Pressure
Temperature: 32° - 150° F (0° - °65 C)Working Temperature
Configuration
For ESP-LXIVM Two-Wire Systems: the Flow Sensor is installed with a Two-Wire Sensor Device (LXIVMSEN)
For ESP-LXD Decoder Systems: the Flow Sensor is installed with a Two-Wire Decoder Sensor Decoder (SD210TURF)
For ESP-LXME2 PRO Systems: the Flow Sensor is attached to the flow terminals on the FSM-LXME2 PRO Base Module
For ESP-LXME Systems: the Flow Sensor is attached to the FSM-LXME Flow Smart Module
For (Hard Wire) Two-Wire Satellite Systems (Maxicom²® and SiteControl): the Flow Sensor is installed with a Pulse Transmitter and a Rain Bird Pulse Decoder (DECPULLR)
For Link Radio Satellite Systems (Maxicom² and SiteControl): the Flow Sensor is installed with a Pulse Transmitter (no pulse decoder required)
For ESP-SITE Satellite Systems (Maxicom): the Flow Sensor is installed with a Pulse Transmitter (no decoder required)
For SiteControl Decoder Systems: the Flow Sensor is installed with a Two-Wire Decoder Sensor Decoder (SD210TURF)
*Surge protection (FSSURGEKIT) is recommended for Maxicom and SiteControl systems – One at the Pulse Transmitter, and if more than 50’ of wire run, one at the Flow Sensor. FSSURGEKIT is not compatible with ESP-LXMEF and ESP-LXD Controllers

More Information

More Information
Model UFS200
Specifications

Dimensions

UFS200 - 10 1/2” x 4 3/4” H = 3 7/8” (267mm x 121mm x 98mm)

Frequently Bought Together
Total price
© 2024 Rain Bird Corporation. All Rights Reserved.