Replacing the Nozzle

• IMPORTANT NOTE: Make sure the sprinkler does not operate automatically while you are changing the nozzle. Turn off the water.
• NOTE: Make sure the snap ring is securely in place before removing the nozzle housing screws.
• Clean top of case assembly to prevent debris from falling in when nozzle housing is removed.
• Required Tools: Phillips-head screwdriver; Flat-head screwdriver.

Image 1 - Use a Phillips-head screwdriver to loosen the nozzle housing screws

Image 2 - Grasp the nozzle housing screws and lift up to separate the nozzle housing from the internal

Image 3 - Press the replacement nozzle assembly into the nozzle housing, making sure the nozzle front is flush with the outside of the housing

Image 4 - An O-ring seal is required on all nozzles.

CAUTION: If the nozzle is not flush and seated properly in the nozzle housing, the rotor may not perform properly.

11000 Nozzles Performance Chart

NOZZLE SPREADER, 11000 SERIES

NOZZLE TAIL GREEN, 11000 SERIES

NOZZLE TAIL PLUG, 11000 SERIES

Kit includes:

• 6 in. Xeri-Pop spray head
• Rain Bird VAN nozzle that has been adjusted for no flow
• 16 in. of  Rain Bird XQ 1/4 in. distribution tubing
• 1/4 in. connection barb
• VAN Nozzle sold separately

• Converts pop-up stem to 1/2 in. (15/21) male pipe thread
• Adapts Rain Bird sprinklers for use with any 1/2 in. (15/21) FPT bubbler or spray nozzle
• Rugged, UV-resistant thermoplastic construction
• Easy to install; no tools required
• Height: 1 1/2 in. (3,8 cm); 0.8 in. (2 cm) above 1800 cap

• Adapts Rain Bird nozzles for use with 1/2 in. (15/21) MPT threaded risers
• Accepts protective, non-clogging 1800 Series filter screen (shipped with nozzle) and PCS Series screens
• Durable, non-corrosive plastic construction
• Fine top threads accept all Rain Bird nozzles

• Adapts Rain Bird nozzles for use with 1/2 in. (15/21) MPT threaded risers
• Accepts protective, non-clogging 1800 Series filter screen (shipped with nozzle) and PCS Series screens
• Durable, non-corrosive plastic construction
• Fine top threads accept all Rain Bird nozzles
• Purple color for easy identification of a non-potable water system

• 45 psi Pressure regulating shrub adapter
• Attaches nozzle to riser to irrigate ground cover and shrub areas requiring pressure regulation
• Rugged thermoplastic construction resists UV rays
• Adapts nozzles for use with 1/2 in. (15/21) MPT threaded risers
• Patented PRS pressure regulator built into the stem
• Fits all Rain Bird nozzles (Nozzle Not Included)

• Pressure regulating shrub adapter
• Attaches nozzle to riser to irrigate ground cover and shrub areas requiring pressure regulation
• Rugged thermoplastic construction resists UV rays
• Adapts nozzles for use with 1/2 in. (15/21) MPT threaded risers.
• Fits all Rain Bird Nozzles (Nozzle not Included).
• Patented PRS pressure regulator built into the stem