Flo-Watch™. Flo-Watch constantly monitors for low flow and excess flow conditions caused by broken lines or heads, automatically quarantines and shuts down the problem area, and continues to irrigate non-affected areas. Saves water, saves plant material, and enables irrigation programs to continue and complete
Learned Flow. The controller automatically learns station flow rates resulting in more accurate flow rates. The automatic collection prevents you from having to manually enter data from drawings, or physically visiting each valve to collect flow data and manually entering the data into a controller
FloManager®. FloManager determines the optimal station irrigating sequence. The system runs at its fullest capacity until programs are complete. The controller automatically selects and runs multiple valves at the same time within hydraulic parameters, allowing for shorter water windows
More Information
More Information
Model
UFS150
Specifications
Dimensions
UFS150- 101/2” x 4 3/4” H = 4 3/8” (267mm x 121mm x 111mm)
Sensor Features Specs
Flow Range
UFS150 - 0.3 - 110 GPM
Sensor Accuracy: +/- 2% across full flow range Velocity: 2-20 Feet (0.6-6.1 meters) per second depending on model and system specifications Pressure: 200 PSI Working Pressure Temperature: 32° - 150° F (0° - °65 C)Working Temperature Configuration For ESP-LXIVM Two-Wire Systems: the Flow Sensor is installed with a Two-Wire Sensor Device (LXIVMSEN) For ESP-LXD Decoder Systems: the Flow Sensor is installed with a Two-Wire Decoder Sensor Decoder (SD210TURF) For ESP-LXME2 PRO Systems: the Flow Sensor is attached to the flow terminals on the FSM-LXME2 PRO Base Module For ESP-LXME Systems: the Flow Sensor is attached to the FSM-LXME Flow Smart Module For (Hard Wire) Two-Wire Satellite Systems (Maxicom²® and SiteControl): the Flow Sensor is installed with a Pulse Transmitter and a Rain Bird Pulse Decoder (DECPULLR) For Link Radio Satellite Systems (Maxicom² and SiteControl): the Flow Sensor is installed with a Pulse Transmitter (no pulse decoder required) For ESP-SITE Satellite Systems (Maxicom): the Flow Sensor is installed with a Pulse Transmitter (no decoder required) For SiteControl Decoder Systems: the Flow Sensor is installed with a Two-Wire Decoder Sensor Decoder (SD210TURF) *Surge protection (FSSURGEKIT) is recommended for Maxicom and SiteControl systems – One at the Pulse Transmitter, and if more than 50’ of wire run, one at the Flow Sensor. FSSURGEKIT is not compatible with ESP-LXMEF and ESP-LXD Controllers